Show Menu

Guitar Frequency Fixes Cheat Sheet by

Guitar Frequency Fixes
tips     music     guitar     frequency     fixes     tuning     tinny     mushy     sounds

Introd­uction

Where can I pin-point that annoying tinny sound from my guitar? What guitar frequency is that? that boomy and muddy sound out of your guitar produc­tion?

Any of those questions sounds familiar?

Just like with every other instru­ment, the guitar responds to boosts and cuts in the audio frequency spectrum. There are specific guitar frequency areas that make the guitar sound a specific way. Here are 7 quick and dirty tricks to make your guitar mixing smoother.

Guitar Tuning

1. Yucky Low-End

Usually, a good place to start your guitar mixing is to filter out the low-end. Cut everything below 100 Hz as a general rule. Filter all the way up until your guitar starts sounding thin, then back off a little.

Acoustic guitars might need a little more bass, especially if there’s no bass. A boost at 80 Hz can lighten the low-end clutter while still giving your acoustic some weight.

2. Guitar Thickness

Add thickness to the guitar in the 150 Hz area. Be careful since you can easily pile on the low-mids, but if your guitar sounds thin then it can benefit from the added thickness from 150-200 Hz. I use this guitar frequency a lot if I feel the guitars should have more bass and power.

3. The Fundam­ental Guitar Frequency

Boosts in the 500 Hz area can compete with the snare drum so make sure that they aren’t clashing with each other.
 

Jam Play Online Tuner

4. Honk and Presence

If your guitar starts sounding tinny or “honky,” a nice cut in the 1-2 kHz can round out the sound. However, if you feel that your guitar lacks presence, you can pull it to the front of the mix by boosting in the 3 kHz area.

5. High Frequency Hiss

Highly distorted guitars can add a substa­ntial amount of hiss and noise to a mix. Be especially careful when you’re boosting in the high mids since you might introduce more hiss than guitar.

6. Vocal Cut-Th­rough Trick

If you feel like the guitar is getting in the way of the vocal, a simple trick is a wide cut around 3-5 kHz. This can clear up that area in order for the vocal to shine through in a busy mix.

7. Brilliance

After giving the vocal some space, you might need to compensate for the now dull guitar sound. Add some slight boosts in the 8 kHz area for some brilli­ance. This works especially well on acoustic guitar and clean electrics. Now the vocal can shine through in its own area as well as giving the guitar some additional grace.

Sweep Around

You might need to sweep around the frequency areas to find the exact freque­ncies where the guitar jumps out and comes alive. Every guitar is different and each one will react differ­ently to a specific guitar frequency.

Use these simple guidelines for a faster EQ workflow. Don’t sweep around the spectrum when you are looking to add some fullness to your guitar. If you already know where you can find it you don’t have to waste time.

Download the Guitar Frequency Fixes Cheat Sheet

1 Page
//media.cheatography.com/storage/thumb/davidpol_guitar-frequency-fixes.750.jpg

PDF (recommended)

Alternative Downloads

Share This Cheat Sheet!

 

Comments

No comments yet. Add yours below!

Add a Comment

Your Comment

Please enter your name.

    Please enter your email address

      Please enter your Comment.

          Related Cheat Sheets

            Guitar Cheat Sheet by Tom Halfhill
          Guitar Tuning Cheat Sheet

          More Cheat Sheets by Davidpol